Editorial desk
KlipperLab Editorial
KlipperLab Editorial is the publishing identity for KlipperLab. It is a desk, not a person: no named author, no biography, no professional certifications.
Articles published under this byline are researched from primary sources — vendor and project documentation, published standards and specifications, research papers, and measurements published by whoever took them — drafted with AI assistance, and edited against those cited sources before publication. Nothing here is based on first-hand testing in a private lab, and any figure that appears is attributed to the source it came from.
Corrections go to hello@klipperlab.com. More detail is on the about page and the editorial disclosure.
Posts (4)
- getting-started
Klipper Hardware Requirements: SBC, MCU, and Sensors
Klipper hardware requirements with Raspberry Pi alternatives, supported BTT, MKS and FYSETC boards, MCU flash methods, and accelerometer connections.
- comparisons
Klipper vs Marlin: Which Firmware Should You Run?
A spec-level comparison of Klipper and Marlin: where motion is computed, how each is configured, what tuning features ship, and who each one suits.
- tuning
Klipper Input Shaper Setup: Wiring and Tuning an ADXL345
Wiring, configuration, and calibration commands for measuring resonance with an ADXL345 in Klipper, plus fixes for the errors that stop a run.
- fundamentals
How Klipper Works: Host, MCU, and printer.cfg
How Klipper works from G-code to step pulses: host planning, MCU timing, printer.cfg changes, protocol communication, and when to reflash firmware.